I need to hold small jewelry items for laser marking but couldn't find a

diycnc-discuss
gplus
(shreyas sagar) #1

I need to hold small jewelry items for laser marking but couldn’t find a suitable vice for holding them. What everyone is using for such applications…any suggestions please…

(Eric Cha) #2

Alligator clips?

(Marcus Wolschon) #3

Maybe something less affected by heat for laser marking.
What about Tesa Power Strips or Frog Tape?

(shreyas sagar) #4

i tried glue/tape also hard wax but heat is a problem…when engraving…

(shreyas sagar) #5

i have also tried clay but sticky/oily marks are a problem as the marked items have to again refinished…:frowning: