I have installed the heated bed upgrade for the Ultimaker Original.

3D Printing
, , ,
1

I have installed the heated bed upgrade for the Ultimaker Original.

In the initial Cura setup it goes through the check of the endstops and I realized that the bed doesn’t have anything extending below it to hit the bottom z endstop as as present on the original bed.

If you have done this upgrade, how did you get this to work?

Thanks

2

The bottom endstop isn’t used anymore after the upgrade. As the UMO homes to the top.
(I’ve modified my UMO to home to the bottom, as the UM2 does. I’ve moved the endstop for this)

3

Thanks!