I have been playing around with Linear Pressure Control with great results.
(things are not working well when using Adaptive Slicing at the same time)
Just out of curiosity, what is your K-factor?
I use a Greg/Wade extruder with 3mm PLA and K=7.7
I have been playing around with Linear Pressure Control with great results.
(things are not working well when using Adaptive Slicing at the same time)
Just out of curiosity, what is your K-factor?
I use a Greg/Wade extruder with 3mm PLA and K=7.7
Which firmware are you referring to?
K values are totally different in different slicers. And some slicers use two parameters.
Oh I see…
This became a very useless post very fast lol