I found one in italian. It's simple to understand.

CAD & CAM Tool Chain LaserWeb/CNCWeb
,
1

I found one in italian. It’s simple to understand. I used it and it works.

Originally shared by Shane Fuga

I just got one of these and I am super duper new to Laser work. I having a really hard time getting it to etch properly or even to scale. Like I’m having it print the fox from the stock gallery with a width of 20mm. Actual width of the Fox is 65mm… Not sure what is going on with that.

So to get started I’m looking for a guide on the EleksMaker Evo Detop CAM 3.1 software or how to get LaserWeb to work with this laser.

2

There was a thread here a couple weeks ago with the same symptoms. Please refer to that thread as it explains how to get the steps/mm programmed in correctly.