I apologize if I over looked this...

I apologize if I over looked this… Are there any instructions on how to wire a 3D probe to the Arduino for Chilipeppr? I am guessing the ground and pin X is all that is needed?

Thank you for the help.

Following… I’m looking for the same info. As far as I know something like this can be built off of the auto level feature,but my programming skills are limited.

There are some videos I put on YouTube of probing in ChiliPeppr but they focus on z axis. There was somebody that did a 3d probe a while back on this Google plus page. I would search for it.

A5 and ground

Thank you for the info.