I am either incredibly dense (entirely possible) or an (obviously) missing something.

Terry_Taylor · June 11, 2017, 9:27pm

I brought a raster file into LaserWeb4, drug it down to lower section, set it to engrave, generated the G-Code, but I cannot figure out a way to add it to the queue to actually engrave.

I seem to remember something about LW3 needing to be run in Chrome, but not sure if the LW4 still runs some of it’s functions in a browser and if i does, how to force it to Chrome.

Ariel_Yahni_UniKpty · June 11, 2017, 9:40pm

@Terry_Taylor did you go to the control tab on the left and press play? ( Make sure you go into the comms tab and connect to the machine first )