Hi I run a K40 using RAMPS and Marlin and my software of choice

Lasers
,
1

Hi

I run a K40 using RAMPS and Marlin and my software of choice is Laserweb4.

I’ve been using the same setup for 18 months with no issue.

I upgraded to the latest version of Laserweb4 a week ago and the profile I had set up for my machine had disappeared from the available list in settings. No big problem I just created a new one. The real issue is that the ‘S’ value set in the gcode is duplicating. Instead of S70 (I set this in the cut profile) the gcode is showing S7070. Again no great issue as I can fix it easily in my text editor.

any ideas?

2

I would go to Github and open an issue there. You will get a faster response I think. Jorges is pretty quick at dealing with issues.

3

+Peter van der Walt

5

@SirGeekALot Peter is no longer a part of the LaserWeb project (He left about a year ago) @Todd_Fleming is the lead on the project now.