Hi guys, İ have a problem with my original prusa i3 mk2:

3D Printing
, , ,
1

Hi guys,

İ have a problem with my original prusa i3 mk2: Often while printing a bigger object this happens: the layer shifts in y or x and I just don’t understand why. I also replaced the belts because they were quite damaged but it still keeps happening and ruining my print. What could be causing the problem, can anybody help me out?

Thanks !

8b255b39403914aa2e486f21ac66309d.jpeg
8b255b39403914aa2e486f21ac66309d.jpeg1920×2560 603 KB

2

Hi I had similar problems on my delta, at some point prints were rotated even. I suggest you to increase the motor current and to tighten the belts further (if possible). But make sure your electronics are not getting to hot, a small fan blowing at the stepper drivers is the way to go!

3

@Flo11 thank you!