HI guys, been a bit quiet of recent and have been busy. I don’t know if anyone UK based would be interested in this. I have a customer that is looking to move on the FB2020 CoreXY I built for them. It was fully built and configured and it’s had an on site visit from myself to make sure everything was running correctly. At this point it’s pretty much, pick up, set up and go, from when I last looked at it. I can provide my S3D Slicing profiles for it. Specs as follows:
A4988 Stepper Drivers
E3D v6 Hot end with Hardened Nozzle
240v mains heated bed
Printbite print surface
0.9 Degree stepper motors
200x200x170 print area
Drakon SLS Extruder.
I’d buy it back, but I’m not floating enough financially atm. It’s a hand built, small volume production printer with not many hours on it. I’ll also throw in my support with it, if you’re interested drop me a message on hangouts and I’ll pass your details on.