Hi folks, I'm using my laser nearly since a year now and have been

Lasers
,
1

Hi folks,
I’m using my laser nearly since a year now and have been successful cutting different materials.
However, I’m not able to do engraving based on something different than a vector graph. What happens is simply, that the laser moves in x-axis only, no recognizable y-movements can be seen.
Could someone share some snapshots of the used settings for successful bitmap engraving? Or does someone faces similar issues?

Thanks,
Timo

2

What software are you running? CorelDraw/CorelLaser or LaserDRW or something else?

3

try saving the file as PNG?

4

I’m running the “original” Corel Draw packet - as mentioned it works fine for vector graphics.
Would be great if someone could share some screenshots (step-by-step) off the laser settings