Hi Folks,
I’m facing a wiered Problem it loks like my laser is doing all mirrored.
I’m new to laser and LaserWeb. I have a Laseraxe laser with grbl_v1.1f-laseraxe Firmware. It works all ok. Besides the Laser Test / Size Check and my biggest Problem the swapped direction/side.
Instead of left he goes right. Instead of right he goes left.
Is there a switch or setting I’m not aware of?
can I change this ?
You can either switch it in the firmware or just rotate the stepper cable 180 degrees ( powered off ).
Can you post your grbl settings?
Have you loocked at: https://github.com/gnea/grbl/wiki/Grbl-v1.1-Configuration
Maybe you can use invert signals in S3.
https://github.com/gnea/grbl/wiki/Grbl-v1.1-Configuration
@Joan_Sunyol hi 
I tryed $3=1 and it Looks like it works.
have I make this command eveerytime now ?
or is it permanent?