Hi everyone. I just finished assembling my printer bot simple metal and everything works great. I was wondering if any other printer bot simple metal owners wanted to recommend any settings to get the best quality prints. So far the prints aren’t that bad but I think they can be better… Any recommendations?
let us know how it performs!
Filament settings are critical. Make sure you measure your filament with calipers. Sadly, filament performance varies wildly. I have some cheap Shaxon filament that works great and some expensive MG Chemical filament that I struggle endlessly with warping.
Be prepared to tinker, troubleshoot, and experiment. Also, print one each of these: http://www.thingiverse.com/thing:507944 and http://www.thingiverse.com/thing:355889