Hey everyone! I just got me TinyG board in the mail today and I’m excited to get fiddling with it. Got turned onto CP and TinyG after going to a meetup here in Costa Mesa and Larry who is a member here and some other guys there were really helpful. I have very little engineering knowledge and everything I know about electronics is self taught but I have been able to put together some steppers and guide rails and wrench out a 2’X2’ CNC laser/router table so I’m not completely clueless. I’m going to build a basic CNC machine to shape surfboards in my garage and then use that to figure out some more complicated stuff. I really look forward to digging into this stuff and chatting with you guys here because I know Ill have a bunch of questions. Thanks in advance for all the help!