Hello, I try to use Laserweb for my ELEKSMAKER using mostly Marco Reps config:

gplus
(Martin Peklo) #1

Hello,
I try to use Laserweb for my ELEKSMAKER using mostly Marco Reps config: https://reps.cc/?p=5

In raster mode all is well and extremely fast, but once I start cutting its painfully slow, a 2cm circle takes minutes to cut, benbox could do that in 2 seconds…
Ramping up cutting speed only increases speed for straight lines, $1=255 (GRBL) helps but only a little, accelleration is already at 1000 and improves things only marginaly…

Does anyone have an idea what I do wrong?
Thanks
Martin