Having a few problems with my first layer fill.

3D Printing
, , ,
21

Only adjustment i made was for calibrating the extruder. This then did give me the exact amount of filament.

I’m still having issues and think i have developed an issue in regards my bed and one of the adjustment screws. Going to strip it down next week and make sure one of the locked nuts is not slipping and thus giving me full adjustment.

Thanks for all the help so far.

22

Ok well i think its so far sorted the first layer problem. ended up stripping down the hot end to ensure it was all fine and dandy. After this and all the other suggestions i managed to print a perfect first layer again. Just pray the rest of the print goes fine lol.

Thanks again.