Haha!!!  Just tried to test out ChiliPeppr with my GRBL controlled original ShapeOko.  Wired

Haha!!! Just tried to test out ChiliPeppr with my GRBL controlled original ShapeOko. Wired it up, Powered it on, Loaded the g-code… then clicked to send the code. I could see the g-code streaming through but my motors weren’t moving!!! AHHH!
Decided to switch over to GRBL Controller. Same thing happened. Then I realized that my E-Stop button was pressed so my motors didn’t have any power! Arghhhhh…
I’ll have to try again on the next job.

Well, welcome to the beautiful world of ChiliPeppr!