GrblGru: Free CAM program with 3D simulation for mills and lathes

Have you tried running it under WINE?

No. Don’t have it installed on this system.

I was able to install the program on Ubuntu using wine but no luck actually running the program. Will have to see if I can tweak wine to run it.

Or, now that it’s installed, maybe you can run it with mono?

@GrblGru Is this based on a fork of FreeCAD? (It looks like FreeCAD)

Thank you for your interest. :slight_smile:
No, GrblGru is self-made and is not based on any other program.
The program is created with C#. The framework 4.0 is integrated. GrblGru runs under Windows from Windows XP upwards.
For the graphics I only used the elementary function of OpenGL. (Points, Lines, Triangles etc.) which is a normal part of C#. All normal stuff, no special features.

1 Like

2 posts were split to a new topic: GrblGru 3.38 Released

4 posts were split to a new topic: GrblGru 3.39 Released

8 posts were split to a new topic: Anti-virus warnings on GrblGru 3.39

A post was split to a new topic: GrblGru 3.40 Released

A post was split to a new topic: GrblGru 3.41 Released

A post was split to a new topic: GrblGru 3.42 Released

A post was split to a new topic: GrblGru 3.43 Released

A post was split to a new topic: GrblGru 3.44 Released

A post was split to a new topic: GrblGru Manual Available

A post was split to a new topic: GrblGru 3.45 Released

A post was split to a new topic: GrblGru 3.46 Released

2 posts were split to a new topic: GrblGru 3.47 Released

A post was split to a new topic: GrblGru 3.48 Released

6 posts were split to a new topic: GrblGru not reporting status correctly on arduino mega 2560