Got the cohesion and laserweb4 to work.

Got the cohesion and laserweb4 to work. I have been able to burn a hole in cardboard. Still need to figure out how to make a pattern and set it up.

But need help with getting software setup.

I am able to move laser using the jog command from LW4 control screen and home it from the Glcd.
But I am not able to home it from the LW4 control screen. Is there a setting I need to change?

How are you trying to home? Send G28.2
What does it do?

I was just trying to click the home all button on the command screen.

You need to configure settings first. We have an article about this on the C3D documentation site.

got it to work thank you. I’ll be back next weekend with more question.