Got all my gear from HK. Can't wait to put it on the car.

Got all my gear from HK. Can’t wait to put it on the car.

@Szymon_Kobalczyk I did. It’s still a little short but I can fix it and upload later tonight…

I’m so jealous… My project is still on “Pause” due to problem with my printer :frowning:
Enjoy @Szymon_Kobalczyk :wink:

challenge accepted lol :wink:

@Szymon_Kobalczyk Sure thing, i will upload both!

@Szymon_Kobalczyk You ran it at full throttle for a minute and it melted? Can you post a picture? Mine are still going…Did you print yours in ABS or PLA?

@Szymon_Kobalczyk Uploaded the new servo holder (Servo Holder for BMS-620MG Servo.B.1.stl) to Thingiverse.

Yes. the rectangular piece is 1mm bigger. It broke first thing but that 1 extra mm did the trick! Note that you need both parts.