gosh i hate this sticky stuff..

gplus
(GoodCodeWriter (Edgar Bull)) #1

gosh i hate this sticky stuff…
but yet at 80°C and ABS it is holding so far… will it hold later on ?

(Lucas Fowler) #2

You are using Zuckerrübensyrop for bed adhesion? !!!

Covers the smell of ABS well I suppose.

(GoodCodeWriter (Edgar Bull)) #3

well working fine so far…but i should have done the calibration for automatic print leveling…because of stress (material wasn’t printed on the layer below) one corner is lifting off now…but i bet it is only internal stress.

(GoodCodeWriter (Edgar Bull)) #4
(Andreas Kahler) #5

Zuckerrübensirup? Well us know how went…

(Hans Franke) #6

Molasses to the rescue!

(GoodCodeWriter (Edgar Bull)) #7

https://plus.google.com/106955573198424559351/posts/XoQKG1arTKU