Google+ post by René Jurack on 2016-08-10 11:51:41 UTC

Rene_Jurack · August 10, 2016, 11:51am

spot-on!

Griffin_Paquette · August 10, 2016, 12:09pm

Nice!!!

Javier_Prieto · August 10, 2016, 12:20pm

Torque?? My bowden tube is crying jajajajaja

Rene_Jurack · August 10, 2016, 12:21pm

holding torque is 13Ncm, lets hope it works with the Titan

Jan_erik_Halvorsen · August 10, 2016, 12:45pm

0.13N are sufficient, Titan have 3: 1 gearing I think. I use 20mm Nema 14 with 0.05N and 4: 1 gearing with no problems.

Nicolas_Arias · August 10, 2016, 1:04pm

@Rene_Jurack , it works!, just fine tune the current and it will be ok

jinx_OI · August 10, 2016, 1:06pm

@Rene_Jurack it works, just been testing one over the weekend

Rene_Jurack · August 10, 2016, 1:16pm

good to know

Topias_Korpi · August 11, 2016, 4:32am

I’m using this kind of stepper with 1:2 gear ratio and it works very well with 1,75mm filament (and with a drive gear with larger diarmeter than standard MK8)