First calibration print had me adjust flow to 0.97, then printed this off.

3D Printing HercuLien and Eustathios
, ,
1

First calibration print had me adjust flow to 0.97, then printed this off. Really happy. Minor stringing to be tuned out. Layers show some contraction at the base. Maybe too much heat on the bed. 210C at the nozzle and 60C on the glass.

Not sure about the general layer inconsistencies. Fist time using hatchbox filament…maybe diameter issues.

Still working on organizing the repo.

f00ed1bd99bf7cdbc60ce63385a48206.jpeg
f00ed1bd99bf7cdbc60ce63385a48206.jpeg1440×2560 264 KB

45a9eee68aaf004ff3a7ea9eb134c326.jpeg
45a9eee68aaf004ff3a7ea9eb134c326.jpeg1440×2560 260 KB

e6bfc91ed0906595d5f419bfba5ca07b.jpeg
e6bfc91ed0906595d5f419bfba5ca07b.jpeg1440×2560 427 KB

b96b94c7bd21a62cf3942cbf445488f1.jpeg
b96b94c7bd21a62cf3942cbf445488f1.jpeg1440×2560 282 KB

36cd57e9db1a25584f98adcababfc896.jpeg
36cd57e9db1a25584f98adcababfc896.jpeg3264×1836 1.66 MB

2

A quick test could be print a 20x20 cube in spiral vase mode, but stretch it out in Z to 100mm or more. Then do the same in a single wall zero infill print. Compare results. And look for Z ribbing.