Final test with Ramps 1.4 running grbl 1.1e. The job is not finished because

Final test with Ramps 1.4 running grbl 1.1e.
The job is not finished because my laptop stopped after one pas. It has 9 pass more to cut the pieces. :confused:

Cool! Where did you get the firmware?

Nevermind. Just read your previous post https://plus.google.com/102797371787170159448/posts/ExDydFf4hLS

Good Enterprise

Hey, that’s my Enterprise design! By the way, I just added instructions with lots of pictures in a PDF file yesterday.

@Jeff_Johnson ​ yes, It is. I Will take a look to this PDF. I need adjust the power of my diode to cut wood correctly.
I like your desing.