Elefu-Ra is finally setup and working on my Mendel-90! Took some serious fiddling with the firmware, but it is a great board despite the hassles. I really like all the lights, and of course the expand-ability…
You must really like screw terminals… Does it have the option to install pin headers at all?
I was looking at that board for a triple extruder setup, but ended up going with RUMBA instead.
I absolutely hate pin headers. Screw terminals make a better, more vibration resistant and reliable connection. I suppose you could install pin headers, although only if the spacing matched on the screw terminals (it comes unassembled.)