Creality K2 Plus vs 13" Mario (6 colours)

3D Printing
1

I recently purchased a K2 plus, and decided to torture test the CFS system.

This was my 3rd print - and in hindsight, a bit ambitious really.

The CFS’s (I have 2) managed to change filaments 1,700 + times without incident.

The print took around 5 days in total, and created enough “poop” to fill a Tesco carrier bag.

As you can see from the timelapse, the priming tower fell about 60% of the way through, which caused issues with the final print :

20250409_071311
20250409_0713113000×4000 1.95 MB

IMG-20250409-WA0008
IMG-20250409-WA00082052×3648 483 KB

Does anyone have any idea why those layer lines are so prominent around the hands and face? Is it just the geometry causing it?

I’m impressed over all with the K2 plus!

1 Like
2

I could be wrong, but watching the time lapse it looks like where you have lines is where you started to lose the priming tower and you may have lost some steps at that point.

3

It has closed loop servos on all axis, so it shouldnt have.

4

Maybe extrusion?

5

This video from Uncle Jessie suggests it may have been because I opened the door.

Interesting, as I did multiple times after the priming tower had fallen.

1 Like