Bonjour les réplicateurs.
10 Months after receiving my REPLICAPE, I decide to upgrade electronics of my MINGDA Glitar 5C.
After successfully test my 2 BullDog extruder with a Chimera, I open the back of Chinese and begins with the cabler Y EndStop and stepper.
At power-up, the 2 extruder grumble, normal Firmware 2.08, but not the Y motor.
After 2 hours of control and reconfiguration in REDEEM, I to connect the Y motor on the stepper X. And it works …
I remove the REPLICAPE and examines the pins, I see nothing , but the Y TMC2100 seem’s have a short-circuit of track right to the exit. Did you already see that?
While waiting for my new REPLICAPE, I will continue integration and playing with slave_y=h