Anyone that has a Makibox A6 HT, what do you think about it, as I was thinking about getting it with the pellet extruder. Thanks!
It’s not out yet. You can see the beta video’s on there website.
The HT, or the extruder?
They haven’t released any of there products yet.
All there products are posted. http://makibox.com/products
They just haven’t shipped anything yet.
I can still buy one, right?
The lead time on there site says 10-12 weeks.
I strongly suggest waiting for them to ship a dozen units and reading some feedback before ordering one.
Ok Thanks for the advice, but that could be a while…
Yup. But throwing $300 on a piece of junk is forever.
they are tooling now, so the lead time is probably 10-12+, the have 600+ backordered currently. there will be some more beta units going out. I am in for one, but if you are going to be in, you must be willing to wait.
What is the pellet extruder?
@matthew_bennett its a device that turns (very cheap) plastic pellets into plastic filament that can be used in a 3D printer. Several of these extruders have surfaced on the market in the past few months.
It takes pellet’s instead of filament. See, http://www.youtube.com/watch?v=OUcBx6nJ5rE