Anyone here have the LO-X7 controller on their K40?

Lasers
,
1

Anyone here have the LO-X7 controller on their K40? If so has anyone configured output functions such as air assist? I have been searching all over google and lightobject and the farthest I got is that you can but I am unable to find out how to configure it.

2

Hi not sure, but seem to be the same product so have a look at their download section here ->
https://www.sinjoe.com/index.php?route=product/product&product_id=96

3

Thanks Stephane, those manuals are similar to the ones provided by LO. I find out that Out1 is on while the job is running and that Out2 is tied to laser output. Out1 is the one to use for air assist. Unfortunately there is no control for if you don’t want it on while engraving which sucks.