Anybody running an ESP32 as 3D printer board?

Anybody running an ESP32 as 3D printer board?

yikes - I hope not?

Someone posted on the Marlin Firmware Github page about working on a Marlin version that runs on it. Work in progress.

Guys on YouTube have done it as a host
https://m.youtube.com/results?search_query=Esp3d

ESP3D works well. It’s not a standalone motion controller but it’s a great web interface!

esp3d looks nice, thanks!

Given that Klipper firmware can eek out some crazy motor control timings on the old 8-bit hardware, I think an ESP32 could probably pull it off.

Ryan is running his own ESP8266 firmware https://github.com/ryannining/karyacontroller