3dBenchy time. First one detached halfway through.

3dBenchy time. First one detached halfway through. Was printing ABS and left the ceiling fan running. Now to enclose the build area.

What’s your secret?! I’ve never gotten a 3dBenchy to come out that well.

@Erik_Scott To fine tune the extrusion steps, I ran 100mm through the hotend while the extruder(hot) was in the middle of the bed. This would be an average point for min/max on x and y printing via the bowden. I saw other methods to set extrusion steps but this seemed to make more sense.