I 3D printed this for my sons office.
Not much of a story, I traced the logo and extruded in Fusion, then sliced into parts to fit my CR-10.
The front face is covered with vinyl.
Final piece stuck to the wall with double sided tape.
Looks really nice in real life !
Looks really nice from here …
What vinyl did you use?
Thanks - I used this :
[vgoltd Gloss Sticky Back vinyl cupboard covering lemon yellow 610mm G1022 (2M) https://amzn.eu/d/9zkGiOD](vgoltd Gloss Sticky Back vinyl cupboard covering lemon yellow 610mm G1022 (2M) https://amzn.eu/d/9zkGiOD)
Very professional looking! I’m kind of stuck on it!
@HalfNormal I did not realize you were made of vinyl.
Nor me - is he cheap as a covering