3040 in its new home.

CAD & CAM Tool Chain ChiliPeppr
1

3040 in its new home. Mounted the PSU and TinyG (thanks @Riley_Porter_ril3y ) on the verticals of this desk. Jogs successfully. Obviously the laptop perched on the drill press is not a feasible solution - I will install a Pi but I do not trust the wifi connectivity in this area. No endstops or PWM control of the spindle yet (manual controller with potentiometer), have touch plate but have not hooked it up yet.

Should add that some of the pics are from last night so you are seeing various stages of wiring before completion.

9198074c8df3c289dbce41b7ab50f0a0.jpeg
9198074c8df3c289dbce41b7ab50f0a0.jpeg3264×2448 976 KB

f3d3ccebc1346538398b227249248106.jpeg
f3d3ccebc1346538398b227249248106.jpeg2448×3264 629 KB

6beb166e3fd628a089dad7305277da99.jpeg
6beb166e3fd628a089dad7305277da99.jpeg2448×3264 666 KB

2

Indeed a nice stand for the laptop, but gravity isn’t your friend here :wink:

3

I put a panel back on the right side of the table and put a laptop there. Will show pic later.

Do I need to know anything special for wiring up the touch probe?