HercuLien and Eustathios   Show & Tell


Topic Replies Activity
About the Show & Tell category 1 February 24, 2019
This seller may be able to make custom beds for the Eustathios! I have 9 January 14, 2019
Top panel finally done! Ran this guy 22 hours a day for a month 2 November 7, 2018
Its been kind of quiet in here lately...figured I would throw this out there 6 October 4, 2018
It has been awhile, 3 September 5, 2018
Needed something to print, 31 April 14, 2018
Enclosure Three years after I started the build, 5 April 4, 2018
If any of you are looking for a Bondtech on a discount hit up 1 April 1, 2018
MRRF is a blast! 3 March 24, 2018
Last night during a print the heater cartridge on my hotend must have caused 12 March 23, 2018
Its not pretty, but its a print. 16 March 15, 2018
I have inconsistent layer registration. 11 March 15, 2018
First print in the books. Everything was going so well until the end there... 6 March 10, 2018
Does a parts cooling fan make a difference; YES! Before: After: 4 March 4, 2018
It Lives! After wrestling with configuring Marlin and cleaning up some wiring, 4 February 23, 2018
Enclosure for the Smoothieboard. 7 February 22, 2018
Just wanted to some honey comb fun for a part I am designing for 5 February 19, 2018
Here are some photos of the cracking. 19 February 14, 2018
So enjoying learning all about printing, infill, etc. 1 February 10, 2018
Well, after quite a few attempts, and lots of questions, 3 February 6, 2018
It does not look pretty, 5 January 25, 2018
And now that she is pretty much done, here is a Marvin at 500%. 5 November 28, 2017
The Hybrid. Always had bad z wobble with the increased height, 2 November 14, 2017
So I'm finally at a point where I have a working derivative/custom Eust. 8 November 12, 2017
McGyver workaround for a broken part 7 July 1, 2017
Well, the lid is done (still got the door to do) 1 May 30, 2017
quick mod on the Herculien. 2 May 24, 2017
500 mm/s ;) : 4 April 20, 2017
Got home today to a nice Little surprise. 6 April 14, 2017
Hey everyone. Printing on my Eusthatios is getting better as my hotend cooling is 13 April 2, 2017