Controllers


Grbl (AVR) This is the location to discuss about AVR based Grbl boards and firmware. More information about grbl can be found at https://github.com/gnea/grbl. Grbl-ESP32 This is the location to discuss Grbl-ESP32 stuff. The Grbl-ESP32 firmware and wiki can be found on https://github.com/bdring/Grbl_Esp32. TinyG All things TinyG! Includes content from the old G+ TinyG community. Mini Gerbil Controller Ask your questions about the Mini Gerbil controller here. Smoothie Chat about all things about the Smoothie firmware, Smoothieboard, and the general Smoothie ecosystem. Grbl-LPC This is the location to discuss grbl-LPC stuff. More information about grbl-LPC can be found at https://github.com/gnea/grbl-LPC. Super Gerbil Controller Ask your questions about the Super Gerbil controller here.
Topic Replies Activity
About the Controllers category 1 March 11, 2019
New 3D delta and all my prints are slanted 1 July 22, 2019
I upgrade to mini gerbil ,don't work need help 9 July 22, 2019
Smoothieboard SD card reading problems 1 July 21, 2019
Smoothieware edge PWM 2 July 20, 2019
New low cost graphical panel for Smoothieware 2 July 11, 2019
Smoothieware: understanding encoder reading readEncoderDelta() 5 July 9, 2019
G32 Problems 2 July 5, 2019
Question on using shell command to upload new G code to SD card 4 July 4, 2019
Aliexpress FYSETC smoothieboard V1.1 MCP4441 issue 5 July 3, 2019
[SOLVED] GCode for Filament swap - M600 3 July 2, 2019
Raster speed issue fixed? 6 July 3, 2019
NVUM V2 Mach3 1 July 3, 2019
MKS SGen can't connect to motherboard with GRBL-LPC 9 July 2, 2019
Ymin not working 8 July 1, 2019
Strange artefacts (motors vibrating) 12 June 30, 2019
Smoothieware halt on boot or reset (and 2 other issues) 4 June 28, 2019
Delta, G29 crashing into the bed, help! 2 June 27, 2019
Stepper motors don't running 11 June 22, 2019
How can I verify that the config.txt file was read properly 2 June 22, 2019
Smoothie - Temperature Runaway - Incorrect error message Help really appreciated 14 June 21, 2019
Viki2 and Re-Arm with Smoothie 2 June 19, 2019
[SOLVED]Smoothie Config, Multiplexing same pin for Fan and Servo 10 June 16, 2019
Does anyone have any experience with the Azteeg X5 GT config setup for 0-10v 7 June 15, 2019
SBase v1.3 GRBL-LPC PWM issues with diode module lasers 23 June 13, 2019
Use any (currently unsupported) stepper drivers on SPI, such as TMC5160 2 June 9, 2019
Endurance 10W laser wiring 13 June 9, 2019
Issues with getting printer with Smoothieboard running 35 June 6, 2019
Smoothie boards not good for CNC? 13 June 6, 2019
BL Touch errors after 1 probe 3 June 6, 2019